Skip to main content

Home
About Us
Systems by Industry
Filters
Baghouses
Bin Vents
Compressed Air Filter
Elf Units
Reverse Air Filter
Cyclones
Equipment
Components
Steel Fabrication
Manuals
Brochures
Reorder Spare Parts
Contact Us
Member Login

Bin Vents


 

 

 

Product Information: Information on this page is for quotation purposes only; not for construction unless certified. Data subject to change without notice. All dimensions are in inches unless noted. 

 

Standard Features
12 gauge mild steel bolted construction to operate up to
+/- 17" [wg]
Lifting lugs on clean air plenum
4" or 6" SCH 40 pipe header for compressed air reservoir
Internal compressed air hard piping
3/4" or 1" diaphragm valves
Blower outlet and header orientation per job
NEMA 4 sequence timer enclosure
3/4" NPT thermocouple coupling in plenum
Magnehelic¨ differential pressure gauge
Unit painted Aircon gray with rust-inhibitive primer on both interior
and exterior surfaces
Fabricated grating in bottom of unit to facilitate bag removal
16 oz. singled polyester, copper wire grounded, bottom-removal
bags with quick-release, stainless steel clamp bands
Bottom-removal galvanized bag cages with aluminum venturies
Hinged access door on side wall
Two sets of installation & maintenance manuals
 115 VAC, 60 Hz. single phase current required for sequence timer with adjustable on time (0.05 to 0.50 sec.) and off time (1.5 to 30 sec.)
230/460 VAC, 60 Hz. three phase current required for TEFC motor mounted on top of fan housing
90 to 100 PSIG clean, dry, uncontaminated compressed air supply required